common problem
Duct processing equipment can produce problems with ducts
Classification :common problemDATE:2017-10-11

Ventilation ducts are an important part of ventilation and air conditioning systems, most of which are made of duct processing equipment (eg duct production lines). However, due to a variety of reasons, may lead to duct processing equipment made of duct problems.

1, processing materials are not up to standard

(1) performance: the surface of the plate is not smooth, uneven thickness, there are obvious indentation, cracks, trachoma, scarring and corrosion, etc.; duct plane subsidence, side outward convex, there are obvious deformation.

(2) Impact: air duct leakage during operation, air conditioning load increases, while the wind life and performance are affected.

(3) Reason: material failure, can not meet the needs of the production duct.

(3) measures: the use of duct manufacturing equipment before the preparation of air duct, the first to check the material factory certificate and material quality proof and appearance thickness, etc., to ensure that the material is available.

2, the wind angle and elbow angle are not allowed

(1) performance: rectangular duct two relative plane, both sides are not parallel; angle is not straight; diagonal is not equal;

(2) Impact: will make the duct connection force is not uniform, the installation of the duct is not straight, the flange is not tight, the system air leakage, resulting in air conditioning load loss, and shorten the service life.

(3) Reason: the board is expected to release the material is not accurate; duct two parallel, the opposite side of the sheet length and width are not equal.

(4) measures: start cutting, the sheet should be strict angle square, the length of each piece of sheet metal, and check the diagonal, so that their deviation is controlled within the allowable range; Check the size of the two sheets of the opposite side of the duct to check the accuracy of the dimensions.

So in order to produce the ducts practical durable high quality, it must be in the duct processing equipment before and after the operation to do a good job before the preparation and to ensure foolproof.

 

RETURN